Toyota Corolla (E170): Light bulbs

You may replace the following bulbs yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your Toyota dealer.

For more information about replacing other light bulbs, contact your Toyota dealer.

Preparing for light bulb replacement

Check the wattage of the light bulb to be replaced.

Share this page:

Other materials:

Evap monitor (vacuum pressure monitor)
Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

Replacement
Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove radiator grille sub–assy Remove the 2 bolts and clip.  using a screwdriver, remove the radiator grille. Hint: tape the screwdriver tip before use. ...

Overhaul
Hint: components: 1. Drain manual transaxle oil (m/t transaxle) torque: 39.2 Nvm (400 Kgf·cm, 29 ft·lbf) 2. Drain automatic transaxle fluid (a/t transaxle) torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 3. Remove front wheel 4. Remove engine under cover lh 5. Remove front axle hub lh nut ...