Toyota Corolla (E120): Lh headlamp assy

Share this page:

Other materials:

Removal & installation and disassembly & reassembly
1. Remove bench type rear seat cushion assy 2. Remove rear floor service hole cover Remove the rear service hole cover. Disconnect the fuel pump and vapor pressure sensor connector. 3. Work for preventing gasoline from spilling out Start the engine.  after the engi ...

Overhaul
Hint: overhaul the rh side by the same procedures with lh side. 1. Remove rear wheel 2. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 3. Remove rear brake drum sub–assy Release the parking brake lever, and remove t ...

On–vehicle inspection
1. Inspection throttle body idle speed control valve assy Notice: it is impossible to check the resister value and the operation of isc valve by itself, because the isc valve has an ic circuit inside it, which transforms the duty signal from the ecm to the derive signal. After check ...