Toyota Tacoma manuals

Toyota Corolla Repair Manual: Knock sensor 1 circuit

Dtc p0325 knock sensor 1 circuit (bank 1 or single sensor)

Dtc p0327 knock sensor 1 circuit low input (bank 1 or single sensor)

Dtc p0328 knock sensor 1 circuit high input (bank 1 or single sensor)

Inspection procedure
Hint: if dtcs besides misfire are memorized simultaneously, first perform the troubleshooting for them. Read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze fr ...

Circuit description
A flat type knock sensor (nonresonant type) has the structure that can detect the vibration in a wider band of frequency from about 6 khz to 15 khz and has the following features. Knock sensors ...

Other materials:

Wireless remote control/electronic key battery
Replace the battery with a new one if it is depleted. You will need the following items: ● Flathead screwdriver ● Small flathead screwdriver ● Lithium battery CR2016 (vehicles without a smart key system), or CR2032 (vehicles with a smart key system) Replacing the battery &# ...

Circuit description
Refer to dtc p0130 Dtc no. Dtc detecting condition Trouble area P0134 After engine is warmed up, heated oxygen sensor (bank 1 sensor 1) output does not indicate rich (greater than 0.45 V) even once when conditions (a), (b), (c), (d) and (e) continue for ...

Moon roof
Use the overhead switches to open and close the moon roof and tilt it up and down. ■ Opening and closing 1 Opens the moon roof* The moon roof stops slightly before the fully open position to reduce wind noise. Press the switch again to fully open the moon roof. 2 Closes the moon roof* ...

2011-2021 Copyright www.tcorolla.net