Toyota Corolla (E120): Intake air temperature circuit

Dtc p0110 intake air temperature circuit

Dtc p0112 intake air temperature circuit low input

Dtc p0113 intake air temperature circuit high input

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the horn button assy.  for the black ...

Rear door belt moulding assy lh
Replacement Hint: the installation procedures are the removal procedures in reverse order. Use the same procedures for the rh side and lh side. 1. Remove rear armrest assy lh 2. Remove power window regulator switch assy rear (w/ power window) 3. Remove rear door window regulator han ...