Toyota Corolla (E120): Fuel pump assy

Share this page:

Other materials:

Circuit description
Refer to dtc p0115 Dtc no. Dtc detection condition Trouble area P0125 If the engine coolant temperature (ect) was less than –6.6 °C (20 °F) when starting the engine, and 20 minutes after the engine start, the ect sensor still indicates below 20 °C (68 ...

On–vehicle inspection
1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...

Inspection procedure
1 Check un–lock warning switch assy Disconnect the key unlock warning switch connector.  check the continuity between the terminals of the key unlock warning switch connector, as shown in the illustration and table. Standard: 2 Check wire harness (tvip ecu unlock warni ...