Toyota Tacoma manuals

Toyota Corolla Repair Manual: Crankshaft position Ц camshaft position correlation

Toyota Corolla Repair Manual / Diagnostics / Sfi system / Crankshaft position Ц camshaft position correlation

Dtc p0016 crankshaft position Ц camshaft position correlation (bank 1 sensor a)

Inspection procedure
Hint Advanced timing over (valve timing is out of specified range) P0011 Retarded timing over (valve timing is out of specified range) P0012 If dtc p0011 or p0012 ...

Circuit description
Refer to dtc p0335 Dtc no. Dtc detection condition Trouble area P0016 Deviation in crankshaft position sensor signal and camshaft position sensor signal (2 tri ...

Other materials:

Shift position uses
*: Shifting to the D position allows the system to select a gear suitable for driving conditions. Setting the shift lever to the D position is recommended for normal driving. ■Downshifting restrictions The shift lever cannot be downshifted if the following speeds are exceeded. mph (km ...

Installing the spare tire
1 Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2 Install the tire and loosely tighten each wheel nut by hand by approximately the sa ...

Roof drip side finish moulding center lh
Replacement Hint: use the same procedures for the rh side and lh side. The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included. 1. Remove roof drip side finish moulding center lh ...

© 2011-2019 Copyright www.tcorolla.net