Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Cruise control system / Idle signal circuit / Circuit description
Toyota Corolla (E120): Circuit description
When the idle switch is turned on, a signal is sent to the cruise control ecu assy. The cruise control ecu assy uses this signal to correct the discrepancy between the throttle valve position and the actuator position sensor values to enable accurate cruise control at the set speed. If the idle switch is malfunctioning, problem symptoms also occur in the engine, so also inspect the engine.

Wiring diagram

Other materials:
Replacement
1. Drain brake fluid
Notice:
wash the brake fluid off immediately if it comes into contact with any painted
surface.
2. Remove front wheel rh
3. Remove front fender liner rh
4. Remove brake actuator with bracket
turn the latch of the actuator connector to disconnect the
connector. ...
Parking brake
Operating instructions
1 To set the parking brake, fully pull the parking brake lever while depressing
the brake pedal.
2 To release the parking brake, slightly raise the lever and lower it completely
while pressing the button.
*1: For U.S.A.
*2: For Canada
■Parking brake engaged wa ...
Console box
Slide the lid to the rear most
position. (vehicles with a
slide function)
Lift the lid while pulling up the
knob.
■Slide function (if equipped)
The console box lid can be slid forward or backward.
WARNING
■Caution while driving
Keep the console box closed.
Injuries may result in the ev ...


