Toyota Corolla (E170): Dialing by selecting a name

1 Select “Phonebook” using 2 Select the desired name using.

2 Select the desired name using and press the off-hook switch. and press the off-hook switch.

By pressing one of the speed dial buttons (from (Add S. Dial) and then one of the speed dial buttons (from to  ) while the desired name is selected, to it can be registered as a speed dial. ) while the desired name is selected, it can be registered as a speed dial.

    Share this page:

    Other materials:

    Dtc check/clear
    1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

    Monitor description
    While the engine is being cranked, the battery positive voltage is applied to terminal sta of the ecm. If the ecm detects the starter control signal (sta) while the vehicle is driving, it will conclude that there is a fault in the starter control circuit. The ecm will turn on the mil and a d ...

    Inspection procedure
    1 Check wire harness(airbag sensor assy center – front seat inner belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat inner belt assy ( ...