Toyota Corolla (E170): Speed dialing

1 Select “Speed dials” using 2 Press the desired preset button (from.

2 Press the desired preset button (from ) and press the off-hook switch. to Dialing by entering the number ) and press the off-hook switch.

    Share this page:

    Other materials:

    Replacement
    1. Disconnect battery negative terminal 2. Remove engine under cover rh 3. Remove starter assy Disconnect the starter connector.  open the terminal cover. remove the nut, then disconnect the starter wire.  remove the 2 bolts, then remove the starter. 4. Install starter a ...

    Circuit description
    The d squib circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0100/13 is recorded when a short is detected in the d squib circuit. Wiring diagram ...

    Turning on light switch does not light up night time illumination of radio receiver
    Wiring diagram Inspection procedure 1 Inspect radio receiver assy(ill+, ill–) Check that the voltage between terminals at each condition, as shown in the chart. Standard: Repair or replace harness or connector ...