Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Supplemental restraint system / Short in p/t squib (lh) circuit / Circuit description
Toyota Corolla (E120): Circuit description
The p/t squib (lh) circuit consists of the airbag sensor assy center and seat belt pretensioner (lh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0135/73 is recorded when a short is detected in the p/t squib (lh) circuit.

Wiring diagram

Other materials:
If a warning light turns on or a
warning buzzer sounds
Calmly perform the following actions if any of the warning
lights comes on or flashes. If a light comes on or flashes, but
then goes off, this does not necessarily indicate a malfunction
in the system. However, if this continues to occur, have the
vehicle inspected by your Toyota dealer.
Actions to ...
Inspection procedure
1 Inspect shift solenoid valve(sl)
Remove the shift solenoid valve sl.
measure the resistance according to the value(s) in the
table below.
Standard:
Connect the positive (+) battery lead to the solenoid connector
terminal, and the negative (–) battery lead to the
so ...
Circuit description
When the ignition switch is turned on, battery positive voltage is applied to
the coilwhich closes the contacts
of the efi main relay (marked: efi) and supplies power to terminal +b of the ecm.
This signal causes current to flow to the coil, closing the contacts of the efi
relay and supplyin ...


