Toyota Corolla (E120): Circuit description

If the ecu detect trouble, it will prohibit abs control, turn on abs warning light, and store the dtc.

Connect terminals tc and cg of the dlc3 to make the abs warning light blink and output the dtc.

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Transmission valve body assy (atm)
    Replacement 1. Remove engine under cover lh 2. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 3. Remove automatic transaxle oil pan sub–assy Remove the 18 ...

    Inspection procedure
    Hand–held tester: 1 Perform active test by hand–held tester(operation of circuit opening relay) Connect the hand–held tester to the dlc3.  turn the ignition switch on and push the hand–held tester main switch on.  select the item ”diagnosis / enhanced obd ii / active ...

    Adjusting the mirrors
    Make sure that you can see backward clearly by adjusting the inside and outside rear view mirrors properly. CAUTION Observe the following precautions. Failure to do so may result in death or serious injury. ●Do not adjust the position of the driver’s seat while driving. Doing so could ...