Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / ABS with EBD system / Abs warning light circuit (does not light up)

Toyota Corolla (E120): Abs warning light circuit (does not light up)

Share this page:

Other materials:

Evap monitor (vacuum pressure monitor)
Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

How to proceed with troubleshooting
1 Vehicle brought to workshop 2 Customer problem analysis 3 Problem symptom confirmation 4 Circuit inspection 5 Repair or replace 6 Confirmation test 7 End Customer problem analysis check ...

Deactivating or stopping the alarm
Do one of the following to deactivate or stop the alarm: ● Unlock the doors or open the trunk. ● Vehicles without a smart key system: Turn the engine switch to the “ACC” or “ON” position, or start the engine. (The alarm will be deactivated or stopped after a few seconds.) & ...