Toyota Corolla (E170) 2014–2019 Owners Manual / Driving / Driving procedures / Continuously variable transmission (vehicles with paddle shift switches) / Shifting the shift lever
Toyota Corolla (E170): Shifting the shift lever
Vehicles without a smart key system:
While the engine switch is in the “ON” position, depress the brake pedal and move the shift lever.
Vehicles with a smart key system: While the engine switch is in IGNITION ON mode, depress the brake pedal and move the shift lever.
When shifting the shift lever between P and D, make sure that the vehicle is completely stopped.
Other materials:
Circuit description
Refer to dtcs p0100
Dtc no.
Dtc detection condition
Trouble area
P0101
After engine is warmed up, conditions (a) to (d) continue for
more than 10 seconds (2 trip detection logic):
engine speed less than 900 rpm
throttle valve fully closed
&nbs ...
Circuit description
The side squib (rh) circuit consists of the airbag sensor assy center and
front seat airbag assy (rh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0110/43 is recorded when a short is detected in the side squib (rh)
circuit.
Wiring diagram
...
Positioning a floor jack
When using a floor jack, follow
the instructions in the
manual provided with the
jack and perform the operation
safely.
When raising your vehicle
with a floor jack, position
the jack correctly. Improper
placement may damage
your vehicle or cause injury.
Location of the jack point
■ Front
■ Rea ...