Toyota Tacoma manuals

Toyota Corolla Repair Manual: Brake warning light circuit

Inspection procedure
Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Perform active test by hand–held tester(abs warning ...

Circuit description
If the ecu detects trouble, it lights the brake warning light at the same time of prohibiting abs control. At this time, the ecu records a dtc in memory. Connect terminals tc and cg of the dlc3 ...

Other materials:

Inspection
1. Inspect driver’s door lock Inspect the door lock motor operation. Standard: If the result is not as specified, replace the door lock assembly. Inspect the door lock and unlock switch continuity. Standard: If the result is not as specified, replace the door lock assembl ...

Evap monitor (vacuum pressure monitor) (continued)
Preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less.* Engine coolant temperature (ect) is between 40°f and 95°f (4.4 °C and 35 °C). Intake air temperature (iat) is between 40°f and 95 °f (4 ...

On–vehicle inspection
1. Inspect turn signal flasher relay circuit Disconnect the connector from the turn signal flasher relay and inspect the connector on wire harness side as shown in the chart. Standard: Connect the connector to the turn signal flasher and inspect the wire harness side connector ...

© 2011-2021 Copyright www.tcorolla.net