Toyota Corolla (E120): Brake booster assy

Share this page:

Other materials:

Removal & installation and disassembly & re
1. Remove bench type rear seat cushion assy (, 72–8) 2. Remove rear floor service hole cover 3. Work for preventing gasoline from spilling out  start the engine.  after the engine has stopped on the its own, turn the ignition switch to lock. 4. Disconnect fuel tank main tu ...

Inspection procedure
1 Check un–lock warning switch assy Disconnect the key unlock warning switch connector.  check the continuity between the terminals of the key unlock warning switch connector, as shown in the illustration and table. Standard: 2 Check wire harness (tvip ecu unlock warni ...

Removal & installation and disassembly & reassembly
1. Remove oxygen sensor Remove a clip and tear off the floor mat.  disconnect a oxygen sensor connector. Remove the oxygen sensor. 2. Remove tail pipe assy Remove 2 bolts, 2 springs and tail pipe assy. 3. Remove floor panel brace front Remove 2 nuts and the ...