Toyota Corolla (E170): Adjusting the screen contrast/brightness

1 Select “General” on the “Display Settings” screen.

2 Adjust the display as desired by selecting “+” or “-”.

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect park/neutral position switch assy Disconnect the park/neutral position switch connector.  measure resistance according to the value(s) in the table below when the shift lever is moved to each position. Standard: 2 Check harness and connector(park/neutral position ...

    Circuit description
    Refer to dtc p0130 Dtc no. Dtc detecting condition Trouble area P0134 After engine is warmed up, heated oxygen sensor (bank 1 sensor 1) output does not indicate rich (greater than 0.45 V) even once when conditions (a), (b), (c), (d) and (e) continue for ...

    Rear wheel alignment
    Inspection 1. Inspect tire 2. Measure vehicle height Notice: before inspecting the wheel alignment, adjust the vehicle height to the specified value. 3. Inspect toe–in Toe–in: usa, canada: Mexico: If the toe–in is not within the specified value, inspect and replace the susp ...