Toyota Corolla (E120) 2002–2008 Repair Manual / Engine control system / Sfi system / On–vehicle inspection
Toyota Corolla (E120): On–vehicle inspection
1. Inspection throttle body idle speed control valve assy

Notice
:
- it is impossible to check the resister value and the operation of isc valve by itself, because the isc valve has an ic circuit inside it, which transforms the duty signal from the ecm to the derive signal.
- After checking, erase the dtc.
- Clear the dtc after inspection.
Hint
: when the isc valve system has malfunctions except for its adherence, dtc p0505 is detected.
- Operation inspection.
- Connect the isc connector to the isc valve.
- Check the isc valve movement when the ignition
switch is turned on.
Movement: half open " fully close " fully open " half open
Hint: isc valve moves within 0.5 Second.
Other materials:
Steering column
Service data
Torque specification
Power steering
Service data
Torque specification
: For use without sst ...
Circuit description
A flat type knock sensor (non–resonant type) has the structure that can
detect the vibration in a wider band
of frequency from about 6 khz to 15 khz and has the following features.
Knock sensors are fitted on the cylinder block to detect the engine knocking.
The sensor contains a piezoele ...
On–vehicle inspection
1. Inspect front axle hub bearing
remove the front wheel.
separate the front disc brake caliper assy .
remove the front disc.
inspect the bearing backlash.
Using a dial indicator, check the backlash near the
center of the axle hub.
Maximum: 0.05 Mm (0. ...


