Toyota Corolla (E120): Replacement

Hint

: components:

1. Precaution

2. Disconnect battery negative terminal

3. Remove air bag front rh sensor

  1. Disconnect the connector from the airbag front rh sensor.
  2.  remove the 2 bolts and airbag front rh sensor.

4. Inspect air bag front rh sensor

5. Install air bag front rh sensor

  1.  check that the ignition switch is turned to off.
  2.  check that the battery negative terminal is disconnected.

    Notice

    : do not start the operation for 90 seconds after removing the terminal.

  3.  install the airbag front rh sensor with the 2 bolts.

    Torque: 8.0 Nvm (82 kgfvcm, 71 invlbf)

  4.  connect the connector to the airbag front rh sensor.
  5.  check that no play is identified.

6. Inspect srs warning light

    Share this page:

    Other materials:

    Tire pressure warning system (if equipped)
    Your vehicle is equipped with a tire pressure warning system that uses tire pressure warning valves and transmitters to detect low tire inflation pressure before serious problems arise. ◆ Installing tire pressure warning valves and transmitters When replacing tires or wheels, tire press ...

    Door control transmitter
    Registration 1. Registration of recognition code Hint: the add mode is used to retain the already registered codes while registering a new recognition code. This mode is used when adding a transmitter. If the number of the registered codes exceeds 4, the previously registered code wi ...

    Inspection procedure
    1 Inspect cruise control actuator assy Turn the ignition switch to off.  disconnect the cruise control actuator assy connector.  measure the resistance between terminals 1 (mo) and 2 (mc) of cruise control actuator assy. Hint: if control plate position is fully opened or ...