Toyota Corolla (E120): Replacement

Hint

: components:

1. Remove floor shift shift lever knob sub–assy

2. Remove console panel upper

3. Remove parking brake hole cover sub–assy

4. Remove console box sub–assy rear

5. Separate floor shift cable transmission control shift

  1. Separate the end of the shift cable from the shift lever assy.

  1. Using a screwdriver, release the cable outer spring.
  2.  turn the lock, separate the shift cable from the shift lever retainer.

6. Separate floor shift cable transmission control select

  1. Separate the end of the select cable from the shift lever assy.

  1. Using a screwdriver, release the cable outer spring.
  2.  turn the lock, separate the select cable from the shift lever retainer.

7. Remove floor shift shift lever assy

  1. Remove the 4 bolts and shift lever assy.

8. Install floor shift shift lever assy

  1. Install the shift lever assy with the 4 bolts.

    Torque: 12 nvm (120 Kgf·cm, 9 ft·lbf)

9. Connect floor shift cable transmission control shift

  1. Connect the shift cable to the retainer of shift lever assy, turn the lock.

    Notice

    : the projecting part of the lock should face upward when the shift cable is installed.

  2.  install the cable outer spring to the lock.

    Notice

    : make sure that after installation the cable outer spring is moved to the place shown in the illustration.

  1. Connect the end of the shift cable to the shift lever assy.

10. Connect floor shift cable transmission control select

  1.  connect the select cable to the retainer of shift lever assy, turn the lock.

    Notice

    : the projecting part of the lock should face upward when the select cable is installed.

  2.  install the cable outer spring to the lock.

    Notice

    : make sure that after installation the cable outer spring is moved to the place shown in the illustration.

  1. Connect the end of the select cable to the shift lever assy.
    Share this page:

    Other materials:

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester. 1 Read value of hand–held tester(skid control sensor) Check that there is no difference between the speed value output from the speed sensor ...

    Circuit description
    The vehicle equipped with abs detects a vehicle speed using the stability control ecu and wheel speed sensor. This sensor monitors a wheel rotation speed and sends the signal to the ecu. The stability control ecu converts these wheel speed signals into a 4–pulse signal and outputs it to ...

    Alarm
    The alarm uses light and sound to give an alert when an intrusion is detected. The alarm is triggered in the following situations when the alarm is set: A locked door or trunk is unlocked or opened in any way other than using the entry function (if equipped), wireless remote control, mechani ...