Toyota Corolla (E170): Windshield wipers and washer

Operating the wiper lever

The wiper operation is selected by moving the lever as follows. When intermittent windshield wiper operation is selected, the wiper interval can be also adjusted.

1 2 Low speed windshield wiper operationIntermittent windshield wiper operation

2 3 High speed windshield wiper operationLow speed windshield wiper operation

3 4 Temporary operationHigh speed windshield wiper operation

4 *1: For U.S.A.Temporary operation

*1: For U.S.A.

*2: For Canada

Wiper intervals can be adjusted when intermittent operation is selected.

Wiper intervals can be adjusted when intermittent operation is selected.

5 Increases the intermittent windshield wiper frequency*3 6 Decreases the intermittent windshield wiper frequency*3

*3: The interval adjuster may not be equipped depending on the grade.

7 Washer/wiper dual operation

7 Washer/wiper dual operation Wipers will automatically operate a couple of times after the washer squirts.

■The windshield wiper and washer can be operated when

■The windshield wiper and washer can be operated when

►Vehicles without a smart key system The engine switch is in the “ON” position.

►Vehicles with a smart key system The engine switch is in IGNITION ON mode.

■If no windshield washer fluid sprays

Check that the washer nozzles are not blocked if there is washer fluid in the windshield washer fluid reservoir.

CAUTION

■Caution regarding the use of washer fluid

When it is cold, do not use the washer fluid until the windshield becomes warm. The fluid may freeze on the windshield and cause low visibility. This may lead to an accident, resulting in death or serious injury.

NOTICE

■When the windshield is dry

Do not use the wipers, as they may damage the windshield.

■When the washer fluid tank is empty

Do not operate the switch continually as the washer fluid pump may overheat.

■When a nozzle becomes blocked

In this case, contact your Toyota dealer.

Do not try to clear it with a pin or other object. The nozzle will be damaged.

    Share this page:

    Other materials:

    Vehicle lift and support locations
    1. Notice about vehicle condition when jacking up As a rule, the vehicle must be unloaded when jacking up. Never jack up or lift up the vehicle loaded with things of heavy weight.  when removing any parts of heavy weight like the engine and transmission, the center of gravity of ...

    Circuit description
    The side squib (rh) circuit consists of the airbag sensor assy center and front seat airbag assy (rh). It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0110/43 is recorded when a short is detected in the side squib (rh) circuit. Wiring diagram ...

    Initialization
    Select “Initialize” using . ● Initializing the sound settings Select “Sound setting” using and press (YES). For details about sound settings: ● Initializing the device information Select “Car Device Info” using and press (YES). Automatic connection of a portable ...