Toyota Corolla (E170): Using the interior lights

Interior lights list

1 Front interior light/personal lights

1 Front interior light/personal lights 2 Rear interior light
3 Engine switch light (vehicles with a smart key system)

Front interior light/personal lights

■ Front interior light

► Type A

► Type B

► Type B

1 Off

1 Off
2 Door position
3 On

■ Personal lights

► Type A

On/off

On/off

► Type B

1 On

1 On
2 Off

When a light is on due to its door link switch, the light will not turn off even if the lens is pressed.

Rear interior light

1 On
2 Door position
3 Off

■Illuminated entry system

■Illuminated entry system

►Vehicles without a smart key system When the interior light switch is in the door position, the interior light automatically turns on/off according to the engine switch position, whether the doors are locked/unlocked and whether the doors are open/closed.

►Vehicles with a smart key system When the interior light switch is in the door position, the interior light and engine switch light automatically turn on/off according to engine switch mode, the presence of the electronic key, whether the doors are locked/unlocked and whether the doors are open/closed.

■To prevent battery discharge

The following lights will go off automatically after 20 minutes:

●Front interior light/personal lights ●Rear interior light ●Trunk light

■Customization

Setting (e.g. the time elapsed before lights turn off) can be changed.

    Share this page:

    Other materials:

    Inspection procedure
    Hint: hand–held tester only: narrowing down the trouble area is possible by performing ”a/f control” active test (heated oxygen sensor or other trouble areas can be distinguished). Perform active test using hand–held tester (a/f control). Hint: ”a/f control” is the active te ...

    Circuit description
    When the ignition switch is turned on, battery positive voltage is applied to the coilwhich closes the contacts of the efi main relay (marked: efi) and supplies power to terminal +b of the ecm. This signal causes current to flow to the coil, closing the contacts of the efi relay and supplyin ...

    Circuit description
    The ecm compares the two waveforms of the heated oxygen sensors located before and after the catalyst to determine whether or not the catalyst performance has deteriorated. Air–fuel ratio feedback compensation keeps the waveform of the heated oxygen sensor in front of the catalyst alterna ...