Toyota Corolla (E120): Replacement

Hint

: components:

1. Precaution

2. Disconnect battery negative terminal

3. Remove air bag front rh sensor

  1. Disconnect the connector from the airbag front rh sensor.
  2.  remove the 2 bolts and airbag front rh sensor.

4. Inspect air bag front rh sensor

5. Install air bag front rh sensor

  1.  check that the ignition switch is turned to off.
  2.  check that the battery negative terminal is disconnected.

    Notice

    : do not start the operation for 90 seconds after removing the terminal.

  3.  install the airbag front rh sensor with the 2 bolts.

    Torque: 8.0 Nvm (82 kgfvcm, 71 invlbf)

  4.  connect the connector to the airbag front rh sensor.
  5.  check that no play is identified.

6. Inspect srs warning light

    Share this page:

    Other materials:

    Exhaust gas precautions
    Harmful substance to the human body is included in exhaust gases if inhaled. CAUTION Exhaust gases include harmful carbon monoxide (CO), which is colorless and odorless. Observe the following precautions. Failure to do so may cause exhaust gases enter the vehicle and may lead to an accident c ...

    Circuit description
    Refer to dtc p0335 Dtc no. Dtc detection condition Trouble area P0016 Deviation in crankshaft position sensor signal and camshaft position sensor signal (2 trip detection logic) Mechanical system (timing chain has jumped a tooth, chain stretch ...

    Circuit description
    The throttle position sensor is mounted in the throttle body and detects the throttle valve opening angle. When the throttle valve is fully closed, a voltage of approximately 0.3 To 1.0 V is applied to terminal vta of the ecm. The voltage applied to terminal vta of the ecm increases in pro ...