Toyota Corolla (E120): Inspection procedure

1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh)

  1. Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  2.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensioner (lh).
  3.  for the connector (on the seat belt pretensioner side) between the airbag sensor assy center and the seat belt pretensioner (lh), measure the resistance between pl+ and body ground.

    Ok: resistance: 1 mΩ or higher

2 Check air bag sensor assy center

2 Check air bag sensor assy center

Sst 09843–18040

  1. Connect the connector to the airbag sensor assy center.
  2.  using a service wire, connect pl+ and pl– of the connector (on the seat belt pretensioner side) between the airbag sensor assy center and the seat belt pretensioner (lh).
  3.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  4. turn the ignition switch to on, and wait at least for 20 seconds.
  5.  clear the dtc stored in memory .
  6.  turn the ignition switch to lock, and wait at least for 20 seconds.
  7.  turn the ignition switch to on, and wait at least for 20 seconds.
  8.  check the dtc .

    Ok: dtc b0137/71 is not output.

Hint

: codes other than code b0137/71 may be output at this time, but they are not relevant to this check.

3 Check p/t squib (lh)

3 Check p/t squib (lh)

Sst 09843–18040

  1. Turn the ignition switch to lock.
  2.  disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  3.  connect the seat belt pretensioner (lh) connector.
  4.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  5.  turn the ignition switch to on, and wait at least for 20 seconds.
  6.  clear the dtc stored in memory .
  7.  turn the ignition switch to lock, and wait at least for 20 seconds.
  8. turn the ignition switch to on, and wait at least for 20 seconds.
  9.  check the dtc .

    Ok: dtc b0137/71 is not output.

Hint

: codes other than code b0137/71 may be output at this time, but they are not relevant to this check.

4 Use simulation method to check

4 Use simulation method to check

Replace all srs components including the wire harness

Replace all srs components including the wire harness

    Share this page:

    Other materials:

    Floor shift cable transmission control shift
    Replacement Hint: components: 1. Remove air conditioner unit assy Hint: refer to the instructions for removal of the air conditioner unit assy. 2. Separate air bag sensor assy center  remove the 3 bolts, separate the airbag sensor assy center. 3. Remove exhaust pipe assy 4. Remo ...

    Terminals of ecu
    Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...

    Inspection and adjustment procedure
    1 Tire valve 2 Tire pressure gauge 1 Remove the tire valve cap. 2 Press the tip of the tire pressure gauge onto the tire valve. 3 Read the pressure using the gauge gradations. 4 If the tire inflation pressure is not at the recommended level, adjust the pressure. If you add too much air, pres ...