Toyota Corolla (E120): Inspection procedure

1 Check side squib(rh) circuit(airbag sensor assy center – front seat airbag assy rh)

  1. Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  2. disconnect the connectors between the front seat airbag assy (rh) and the airbag sensor assy center.
  3.  release the airbag activation prevention mechanism of the connector (on the airbag sensor assy center side) between the airbag sensor assy center and the front seat airbag assy (rh) .
  4.  for the connector (on the front seat airbag assy side) between the airbag sensor assy center and the front seat airbag assy (rh), measure the resistance between sfr+ and sfr–.

    Ok: resistance: 1 mw or higher

2 Check air bag sensor assy center

2 Check air bag sensor assy center

Sst 09843–18040

  1. Connect the the connector to the airbag sensor assy center.
  2.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  3.  turn the ignition switch to on, and wait at least for 20 seconds.
  4.  clear the dtc stored in memory .
  5.  turn the ignition switch to lock, and wait at least for 20 seconds.
  6.  turn the ignition switch to on, and wait at least for 20 seconds.
  7.  check the dtc .

    Ok: dtc b0110/43 is not output.

Hint

: codes other than code b0110/43 may be output at this time, but they are not relevant to this check.

3 Check side squib(rh)

3 Check side squib(rh)

Sst 09843–18040

  1. Turn the ignition switch to lock.
  2.  disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  3.  connect the front seat airbag assy (rh) connector.
  4.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  5. turn the ignition switch to on, and wait at least for 20 seconds.
  6.  clear the dtc stored in memory .
  7.  turn the ignition switch to lock, and wait at least for 20 seconds.
  8.  turn the ignition switch to on, and wait at least for 20 seconds.
  9.  check the dtc .

    Ok: dtc b0110/43 is not output.

Hint

: codes other than code b0110/43 may be output at this time, but they are not relevant to this check.

Use simulation method to check

Use simulation method to check

    Share this page:

    Other materials:

    Wiper rubber lh
    Replacement 1. Remove fr wiper blade lh  remove the front wiper blade lh from the front wiper arm lh. Notice: do not fold down the front wiper arm with the front wiper blade being removed from it. 2. Remove wiper rubber lh  remove the front wiper rubber lh from the front wi ...

    Skid control sensor
    Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire Disconnect the skid control sensor wire connector from the skid control sensor. 4. Remove rear axle hub & ...

    Precaution
    1. Precaution of headlight bulb replacement  if even a thin film of oil is left on the surface of the halogen lamp, its service life will be shortened because the lamp will be burn at a higher temperature.  handle any halogen lamp with great care. Dropping, hitting or damagin ...