Toyota Corolla (E120) 2002–2008 Repair Manual / Automatic transmission / trans / Speedometer sensor (atm)
Toyota Corolla (E120): Speedometer sensor (atm)
Replacement
1. Remove air cleaner case
2. Remove air cleaner hose no.1
3. Remove speedometer sensor
- disconnect the connector.
- remove the bolt and speedometer sensor assembly.
- remove the clip and driven gear from the speedometer sensor.
4. Install speedometer sensor
- Coat a o–ring with atf and install it to the speedometer sensor.
- install the driven gear to the speedometer sensor with the clip.
- install the speedometer sensor assembly with the bolt.
Torque: 11.3 N·m (115 kgf·cm, 9 ft·lbf)
- connect the connector.
5. Install air cleaner hose no.1
6. Install air cleaner case
torque: 7.0 Nvm (71 Kgf·cm, 62 in.Vlbf)
Other materials:
Circuit description
The airbag sensor front lh circuit consists of the airbag sensor assy center
and airbag sensor front lh.
Dtc b1158/b1159/16 is recorded when malfunction is detected in the airbag sensor
front lh circuit.
Wiring diagram
...
Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal)
Turn the ignition switch to on.
measure voltage between terminals tc and cg of dlc3.
Ok:
voltage: 10 – 14 v
2 Check harness and connector(dlc3 – body ground)
Check for open and short circuit in harness and connector betw ...
Inspection
1. Headlamp dimmer switch assy
Inspect light control switch continuity.
Measure the resistance according to the value(s) in
the table below.
Standard:
Inspect headlight dimmer switch continuity.
Measure the resistance according to the value(s) in
the tabl ...