Toyota Corolla (E120): Front axle lh hub bolt

Replacement

Hint

: components:

1. Remove front wheel

2. Separate front disc brake caliper assy lh

3. Remove front disc

4. Remove front axle lh hub bolt

  1. Using sst and a hammer handle or an equivalent, remove the lh hub bolt.

    Sst 09628–10011

5. Install front axle lh hub bolt

  1. Install a washer and nut to a new lh hub bolt as shown in the illustllation.
  2. using a hammer handle or an equivalent to hold the hub sub–assy lh, install the lh hub bolt by tightening the nut.

6. Install front disc

7. Install front disc brake caliper assy lh

8. Install front wheel

torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)

    Share this page:

    Other materials:

    Vehicle control system
    Ignition or starter switch assy Replacement 1. Remove steering column cover 2. Remove ignition or starter switch assy Disconnect the ignition switch connector and unlock warning switch connector.  remove the 2 clamps.  remove the 2 screws and ignition switch. Inspectio ...

    Using the steering wheel switches
    The steering wheel switches can be used to operate a connected cellular phone or portable digital audio player (portable player). Operating a Bluetooth® phone using the steering wheel switches 1 Volume The voice guidance volume cannot be adjusted using these buttons. 2 Off-hook switch Turns ...

    Folding the mirrors
    Push the mirror back in the direction of the vehicle’s rear. ■Mirror angle can be adjusted when ► Vehicles without a smart key system The engine switch is in the “ACC” or “ON” position. ►Vehicles with a smart key system The engine switch is in ACCESSORY or IGNITION ...