Toyota Corolla (E120): Circuit description

1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy)

  1. Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  2.  disconnect the connectors between the airbag sensor assy center and the instrument panel passenger airbag assy.
  3. for the connector (on the instrument panel passenger airbag assy side) between the airbag sensor assy center and the instrument panel passenger airbag assy, measure the resistance between p+ and p–.

    Ok: resistance: below 1 Ω

2 Check air bag sensor assy center

2 Check air bag sensor assy center

Sst 09843–18040

  1. Connect the connector to the airbag sensor assy center.
  2.  using a service wire, connect p+ and p– of the connector (on the instrument panel passenger airbag assy side) between the airbag sensor assy center and the instrument panel passenger airbag assy.
  3.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  4.  turn the ignition switch to on, and wait at least for 20 seconds.
  5.  clear the dtc stored in memory .
  6.  turn the ignition switch to lock, and wait at least for 20 seconds.
  7.  turn the ignition switch to on, and wait at least for 20 seconds.
  8.  check the dtc .

    Ok: dtc b0106/54 is not output.

Hint

: codes other than code b0106/54 may be output at this time, but they are not relevant to this check.

3 Check p squib

3 Check p squib

Sst 09843–18040

  1. Turn the ignition switch to lock.
  2.  disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.
  3.  connect the instrument panel passenger airbag assy connector.
  4.  connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.
  5.  turn the ignition switch to on, and wait at least for 20 seconds.
  6.  clear the dtc stored in memory .
  7.  turn the ignition switch to lock, and wait at least for 20 seconds.
  8.  turn the ignition switch to on, and wait at least for 20 seconds.
  9.  check the dtc .

    Ok: dtc b0106/54 is not output.

Hint

: codes other than code b0106/54 may be output at this time, but they are not relevant to this check.

Use simulation method to check

Use simulation method to check

    Share this page:

    Other materials:

    Types of child restraints
    Child restraint systems are classified into the following 3 types according to the age and size of the child: ► Rear facing - Infant seat/convertible seat ► Forward facing - Convertible seat ► Booster seat ■Selecting an appropriate child restraint system ●U ...

    Adjustment
    1. Inspect shift lever position When shifting the shift lever to each position, make sure that it moves smoothly, and the position indicator displays correctly. Positions which can be shifted without pressing the shift lever knob button r " n " d, l " 2 " d &quo ...

    Body rocker panel moulding lh
    Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove body rocker panel moulding lh Remove the 8 retainers.  using a screwdriver, remove the moulding. Hint: tape the screwdriver tip before use.  remove the 7 clips from the moulding. 2. Insta ...