Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Electronic controlled automatic transaxle / O/d main switch circuit / Inspection procedure
Toyota Corolla (E120): Inspection procedure
1 Check harness and connector(transmission control switch – body ground)
- Disconnect the transmission control switch connector of shift lever assy.
- measure the resistance according to the value(s) in the table below.
Standard:
2 Inspect transmission control switch
- Measure the resistance according to the value(s) in the table below.
Standard:
3 Check harness and connector(transmission control switch – ecm)
- Connect the transmission control switch connector of shift lever assy.
- disconnect the ecm connector.
- measure the resistance according to the value(s) in the table below.
Standard:
Proceed to next circuit inspection shown on problem symptoms table
Other materials:
Circuit description
When a misfire occurs in the engine, hydrocarbons (hc) enter the exhaust in
high concentrations. If this hc
concentration is high enough, there could be an increase in exhaust emissions
levels. High concentrations
of hc passing through the catalyst also cause to temperature of the catalyst to ...
Brake
Service data
Torque specification
Parking brake
Service data
Torque specification
...
Inspection procedure
1 Inspect shift solenoid valve(s1)
Remove the shift solenoid valve s1.
measure the resistance according to the value(s) in the
table below.
Standard:
Connect the positive (+) battery lead to the solenoid connector
terminal, and the negative (–) battery lead to the
solenoid ...