Toyota Corolla (E120): Inspection procedure
1 Check un–lock warning switch assy
- Disconnect the key unlock warning switch connector.
- check the continuity between the terminals of the key unlock warning switch connector, as shown in the illustration and table.
Standard:
2 Check wire harness (tvip ecu unlock warning switch)
- Disconnect the tvip ecu and key unlock warning switch connectors.
- check the continuity between the terminals of the tvip ecu connectors and unlock warning switch connector, as shown in the illustration and table.
Standard:
3 Check wire harness (key unlock warning switch body ground)
- Disconnect the key unlock warning switch connector.
- check the continuity between the terminal of the key unlock warning switch connector and the body ground, as shown in the illustration and table.
Standard:
Check and replace tvip ecu
Other materials:
Changing gear steps in the M position
To enter 7-speed sport sequential shiftmatic mode, shift the shift lever to M.
Gear steps can then be selected by operating the shift lever, allowing you to drive
in the gear step of your choosing.
1 Upshifting
2 Downshifting
The gear changes once every time the shift lever is operated.
The ...
Data list/active test
1. Data list
Hint:
according to the data list displayed by the obd ii scan tool or hand–held
tester, you can read the value
of the switch, sensor, actuator and so on without parts removal. Reading the
data list as the first step of
troubleshooting is one method to shorten labor time.
W ...
Floor shift cable transmission control select
Replacement
Hint: components:
1. Remove air conditioner unit assy
Hint:
refer to the instructions for removal of the air conditioner unit assy.
2. Separate air bag sensor assy center
remove the 3 bolts, separate the airbag sensor assy center.
3. Remove exhaust pipe assy
4. Remo ...