Toyota Corolla (E120): Definition of terms

Term

Definition

Monitor description Description of what the ecm monitors and how it detects malfunctions (monitoring purpose and its details).
Related dtcs Diagnostic code
Typical enabling condition Preconditions that allow the ecm to detect malfunctions.

With all preconditions satisfied, the ecm sets the dtc when the monitored value(s) exceeds the malfunction threshold(s).

Sequence of operation The priority order that is applied to monitoring, if multiple sensors and components are used to detect the malfunction.

While another sensor is being monitored, the next sensor or component will not be monitored until the previous monitoring has concluded.

Required sensor/components The sensors and components that are used by the ecm to detect malfunctions.
Frequency of operation The number of times that the ecm checks for malfunctions per driving cycle.

”Once per driving cycle” means that the ecm detects malfunction only one time during a single driving cycle.

”Continuous” means that the ecm detects malfunction every time when enabling condition is met during a single driving cycle.

Duration The minimum time that the ecm must sense a continuous deviation in the monitored value(s) before setting a dtc. This timing begins after the ”typical enabling conditions” are met.
Malfunction thresholds Beyond this value, the ecm will conclude that there is a malfunction and set a dtc.
Mil operation Mil illumination timing after a defect is detected.

”Immediately” means that the ecm illuminates mil the instant the ecm determines that there is a malfunction.

”2 Driving cycle” means that the ecm illuminates mil if the same malfunction is detected again in the 2 nd driving cycle.

    Share this page:

    Other materials:

    Overhaul
    1. Remove oil filler cap sub–assy Remove the oil filler cap from the cylinder head cover. 2. Remove oil filler cap gasket Using a screwdriver, remove the gasket from the oil filler cap. 3. Remove ventilation valve sub–assy Remove the ventilation valve from the cyl ...

    Unlocking and locking the doors from the outside
    ◆ Smart key system (if equipped) Carry the electronic key to enable this function. 1 Grip the driver’s door handle to unlock the door. Grip the passenger’s door handle to unlock all the doors.* Make sure to touch the sensor on the back of the handle. The doors cannot be unlocked for ...

    Inspection procedure
    1 Check operation(overdrive) Drive the vehicle after the engine warms up.  check that overdrive on e off occurs by an operation of the o/d switch on–off. 2 Inspect terminal voltage(od) Remove the cruise control ecu assy with the connector still connected.  tur ...