Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Audio system / Cd cannot be inserted or is ejected right after insertion

Toyota Corolla (E120): Cd cannot be inserted or is ejected right after insertion

Wiring diagram

Inspection procedure

1 Check if a proper cd is inserted

  1. Check that a proper cd is inserted.
  1.  Make sure that the cd is normal audio cd, and that there is no deformation, flaw, stain, burr and other defects on the cd.

    Standard: normal audio cd.

Reference:

  • translucent or different–shaped cd cannot be played.
  • Cd–rom for personal computers (with music recorded in) and recorded cd–r may not be played.
  • Playing an 3.2 In. (8–Cm) cd does not require an adapter.

2 Check that a proper cd is inserted

2 Check that a proper cd is inserted

  1. Check that a proper cd is inserted.
  1.  Check whether or not the cd is inserted upside down.

    Standard: not upside down.

3 Disc cleaning

3 Disc cleaning

  1. Disk cleaning
  1.  if the disk gets dirty, clean the disk by wiping the surface from the center to outside in the radial directions with a soft cloth.

Notice

: do not use a conventional record cleaner or anti–static preservative.

4 Replace cd with another and recheck

4 Replace cd with another and recheck

  1. Replace the cd with another and recheck.
  1.  Replace the faulty cd with the normal one to see if the same trouble occurs again.

    Standard: malfunction disappear.

5 Check if radio auto–search functions properly

5 Check if radio auto–search functions properly

  1. Check if the radio auto–search function properly.
  1.  Perform the auto–research of the radio and check that the operation is normal.

    Standard: malfunction disappear.

6 Inspect radio receiver assy(+b, acc, gnd)

6 Inspect radio receiver assy(+b, acc, gnd)

  1. Check that the continuity between terminals at each condition, as shown in the chart.

Standard:

  1. Check that the voltage between terminals at each condition, as shown in the chart.

Standard:

Repair or replace harness or connector

Repair or replace harness or connector

    Share this page:

    Other materials:

    Circuit description
    Refer to dtc p0115 Dtc no. Dtc detection condition Trouble area P0125 If the engine coolant temperature (ect) was less than –6.6 °C (20 °F) when starting the engine, and 20 minutes after the engine start, the ect sensor still indicates below 20 °C (68 ...

    Inspection procedure
    1 Check operation(starter) Check that the starter operates normally and that the engine starts. 2 Input signal check See input signal check on page 05–745.  check the indicator light when shifting into except d position. Ok: the indicator light goes off when shifting ...

    Malfunction in fuel receiver gauge
    Wiring diagram Inspection procedere 1 Inspect fuel sender gage assy Disconnect the connector fuel sender gauge. check the float position between e and f and measure the resistance between terminals 2 and 3 of the connector. Check that the resistance value changes continuously. S ...