Toyota Corolla (E170) 2014–2019 Owners Manual / Interior features / Using the voice command system (Multimedia system)

Toyota Corolla (E170): Using the voice command system (Multimedia system)

Voice command system

The voice command system enables the hands-free system to be operated using voice commands.

Operations of the voice command system can be performed by selecting the menu corresponding to each function on the screen. Even if any menu is selected, commands displayed on all menus can be operated.

Using the voice command system

1 Press the talk switch.

To cancel the voice command system, press and hold the talk switch.

2 After a beep sounds, say the desired command.

2 After a beep sounds, say the desired command.

On the list screen, you can select the desired command.

Microphone

 

When using the microphone

●It is unnecessary to speak directly into the microphone when giving a command.

●It is not necessary to wait for the confirmation beep before speaking a command.

●Voice commands may not be recognized if:

• Spoken too quickly.

• Spoken at a low or high volume.

• The roof or windows are open.

• Passengers are talking while voice commands are spoken.

• The air conditioning speed is set high.

• The air conditioning vents are turned towards the microphone.

●In the following conditions, the system may not recognize the command properly and using voice commands may not be possible: • The command is incorrect or unclear. Note that certain words, accents or speech patterns may be difficult for the system to recognize.

• There is excessive background noise, such as wind noise.

Casual speech recognization

Due to natural language speech recognition technology, this system enables recognition of a command when spoken naturally. However, the system cannot recognize every variation of each command.

In some situations, it is possible to omit the command for the procedure and directly state the desired operation.

Not all voice commands are displayed in the short cut menu.

This function is available in English, Spanish and French.

■ Expression examples for each function

Command list

Command list

Some recognizable voice commands and their actions are shown below as examples.

► Basic

► Phone

► Phone

Interior features

    Share this page:

    Other materials:

    Inspection procedure
    1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

    Inspection procedure
    Hint: read freeze frame data using the hand–held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, th ...

    Overhaul
    1. Remove generator pulley Sst 09820–63010 (09820–06010, 09820–06020) Hint: Hold sst 1 – a with a torque wrench, and tighten sst 1 – b clockwise to the specified torque. Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf) Notice: check that sst is secured to the rotor shaft. ...