Toyota Corolla (E120): Precaution
1. Handling precautions on steering system
- care must be taken when replacing parts. Incorrect replacement may affect the performance of the steering system and result in a driving hazard.
2. Handling precautions on srs airbag system
- the vehicle is equipped with srs (supplemental restraint system) such as the driver airbag and front passenger airbag. Failure to carry out service operation in the correct sequence could cause the srs to unexpectedly deploy during servicing, possibly leading to a serious accident. Before servicing (including removal or installation of parts, inspection or replacement), be sure to read the precautionary notice for the supplemental restraint system
Other materials:
Circuit description
The crankshaft position sensor (ne signal) consists of a magnet, iron core
and pickup coil.
The ne signal plate (crankshaft position sensor plate) has 34 teeth and is
installed on the crankshaft. The
ne signal sensor generates 34 signals for each engine revolution. This sensor
monitors a p ...
Installing the spare tire
1 Remove any dirt or foreign matter from the wheel contact surface.
If foreign matter is on the wheel contact surface, the wheel nuts may loosen
while the vehicle is in motion, causing the tire to come off.
2 Install the tire and loosely tighten each wheel nut by hand by approximately
the sa ...
Inspection procedure
1 Check p/t squib(rh) circuit(airbag sensor assy center – front
seat outer belt assy rh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the seat belt pretensio ...