Toyota Corolla (E120): On–vehicle inspection

1. Check basic function (manual operation function)

  1.  turn the ignition switch on.
  1.  Check that the door glass moves up when each window switch of the regulator master switch assembly is turned up and moves down when each window switch is turned down.
  2.  Check that the door glass moves up when the window switch of each regulator switch assembly is turned up and moves down when the window switch is turned down.
  3.  Check that the other door glasses than the driver’s door glass do not operate when the window lock switch is turned lock.

2. Check automatic operation function

  1.  turn the ignition switch on.
  1.  Check that the auto down operates and the door glass is fully opened when each window switch of the regulator master switch assembly is turned down by double–shift.
  2.  Check that the auto down operates and the door glass is fully opened when the window switch of each regulator switch assembly is turned down by double–shift.
  3.  Check that the door glass stops when the applicable switch is turned up during the auto down operation. (However, if the switch is kept in the up side, the window will transfer to the manual operation.)

Problem symptoms table

Inspection

    Share this page:

    Other materials:

    Shift position uses
    *: Shifting to the D position allows the system to select a gear suitable for driving conditions. Setting the shift lever to the D position is recommended for normal driving. ■Downshifting restrictions The shift lever cannot be downshifted if the following speeds are exceeded. mph (km ...

    Overhaul
    1. Drain clutch fluid 2. Remove brake master cylinder sub–assy 3. Remove brake booster assy 4. Disconnect clutch reservoir tube Loosen the clip and disconnect the clutch reservoir tube from the clutch master cylinder assy. Hint: use a container to catch the fluid. 5. Disconnect ...

    Data list/active test
    1. Data list Hint: according to the data list displayed by the obd ii scan tool or hand–held tester, you can read the value of the switch, sensor, actuator and so on without parts removal. Reading the data list as the first step of troubleshooting is one method to shorten labor time. W ...