Toyota Corolla (E120): Inspection procedure

1 Check door lock

  1. When the door does not operate manually, proceed to ”a”.
  2.  when the door does not operate via the key, proceed to ”b”.

2 Inspect door lock control switch

2 Inspect door lock control switch

  1. W/ power window: remove the power window regulator master switch assy.
  1.  Inspect the master switch (door lock control switch) continuity, as shown in the illustration and table.

Standard:

  1. W/o power window: remove the door lock control switch.
  1.  Inspect the door lock control switch continuity, as shown in the illustration and table.

Standard:

3 Check wire harness (switch  integration relay)

3 Check wire harness (switch  integration relay)

  1. W/ power window: disconnect the power window regulator master switch assy and integration relay connectors.

    W/o power window: disconnect the door lock control switch and integration relay connectors.

  2.  check the continuity between the terminals of the power window regulator master switch assy or door lock control switch and integration relay connectors, as shown in the illustration and tables.

[W/ power window] standard (check for open):

[W/o power window]

[W/o power window] standard (check for open):

4 Inspect driver’s door lock

4 Inspect driver’s door lock

  1. Inspect the driver’s door lock key switch.
  2. inspect the driver’s door lock position switch.

5 Check wire harness (driver’s door lock  integration relay)

5 Check wire harness (driver’s door lock  integration relay)

  1. Disconnect the driver’s door lock and integration relay connectors.
  2.  check the continuity between the terminals of the driver’s door lock and integration relay connectors, as shown in the illustration and table.

Standard (check for open):

Replace integration relay

Replace integration relay

    Share this page:

    Other materials:

    Terminals of ecu
    1. Inspect integration relay Disconnect the connector and check the continuity of each terminal of the disconnected connector. Standard : If the result is not as specified, the vehicle’s side may malfunction. Reconnect the connector and check each terminal. Standard: If ...

    Pre–check
    1. Srs warning light check Turn the ignition switch to the on position and check that the srs warning light lights up. check that the srs warning light goes out after approx. 6 Seconds. Hint: when the ignition switch is at on and the srs warning light remains on or flashes, the ...

    How to use this manual
    1. Body panel replacement in this manual 2. Symbols 3. Illustration of weld point symbols ...