Toyota Corolla (E120): Inspection procedure
1 Inspect transmission wire(s2)
- Disconnect the transmission wire connector from the transaxle.
- measure the resistance according to the value(s) in the table below.
Standard:
2 Check harness and connector(transmission wire – ecm)
- Connect the transmission connector to the transaxle.
- disconnect the connector from the ecm.
- measure the resistance according to the value(s) in the table below.
Standard:
Replace ecm
3 Inspect shift solenoid valve(s2)
- Remove the shift solenoid valve s2.
- measure the resistance according to the value(s) in the table below.
Standard:
- Connect the positive (+) battery lead to the solenoid connector terminal, and the negative (–) battery lead to the solenoid body for checking the solenoid valve operation.
Standard: the solenoid makes an operating noise.
Repair or replace transmission wire
Other materials:
Side mudguard sub–assy lh
Replacement
Hint:
use the same procedures for the rh side and lh side.
1. Remove side mudguard sub–assy lh
Using a clip remover, remove the 8 retainers and 9 clips.
using a moulding remover, remove the mudguard.
2. Install side mudguard sub–assy lh
Install the mudgu ...
Replacement
Hint: components:
1. Remove front wheel
2. Remove front axle hub lh nut
sst 09930–00010
3. Separate front stabilizer link assy lh
4. Separate speed sensor front lh (w/ abs)
5. Separate front disc brake caliper assy lh
Remove the 2 bolts, separate the brake caliper assy ...
Inspection procedure
1 Inspect stop lamp switch assy
2 Check harness and connector(stop lamp switch assy – ecm)
Install the stop lamp switch assy.
disconnect the ecm connector.
measure the voltage according to the value(s) in the table
below when the brake pedal is depressed and rele ...