Toyota Corolla (E120): Inspection procedure

1 Reconfirm dtc

  1. Check the dtc

2 Inspect skid control ecu connector securely connected

2 Inspect skid control ecu connector securely connected

3 Inspect skid control ecu connector(ig1 terminal voltage)

3 Inspect skid control ecu connector(ig1 terminal voltage)

In case of using hand–held tester:

  1.  check the voltage condition output from the ecu displayed on the hand–held tester.

    Ok: ”normal” is displayed.

In case of not using hand–held tester:

In case of not using hand–held tester:

  1.  disconnect the skid control ecu connector.
  2.  turn the ignition switch to on.
  3. measure voltage between terminals ig1 (3) and gnd (1, 23) of skid control ecu harness side connector.

    Ok: oltage: 10 – 14 v

4 Inspect skid control ecu connector(gnd terminal continuity)

4 Inspect skid control ecu connector(gnd terminal continuity)

  1. Measure resistance between terminal gnd (s1–2, 24) of skid control ecu harness side connector and body ground.

    Resistance: 1 Ω or less

Check and repair harness and connector

Check and repair harness and connector

5 Go to combination meter system(abs warning light)

  1. Disconnect the skid control ecu connector.
  2.  using service wire, connect terminals wa (30) and gnd (1, 23) of skid control ecu harness side connector.
  3.  turn the ignition switch to on.

    Ok: abs warning light goes off.

Check and replace brake actuator assy

Check and replace brake actuator assy

    Share this page:

    Other materials:

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...

    Inspection procedure
    1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

    Listening to an iPod
    Connecting an iPod enables you to enjoy music from the vehicle speakers. Press until “iPod” is displayed. Connecting an iPod Control panel 1 Power 2 Volume 3 Fast-forward or reverse 4 Repeat play 5 Shuffle playback 6 Select an iPod menu/song or display song list 7 Displays text mess ...