Toyota Corolla (E120): Heater control & accessory assy

Replacement

1. Remove console panel upper

2. Remove instrument cluster finish panel

3. Remove heater control & accessory assy

  1. Release the 2 fitting claws and pull out the heater control & accessory assy.

  1. Using a screwdriver, open the claw of the cable clamp and disconnect the defroster damper control cable.

Notice

:

  • be careful not to bend the cable wire.
  • If the cable wire bends, the heater control & accessory assy operationality becomes worse.

Hint

: tape the screwdriver tip before use.

  1. Using a screwdriver, open the claw of the cable clamp and disconnect the air mix damper control cable.

Notice

:

  • be careful not to bend the cable wire.
  • If the cable wire bends, the heater control & accessory assy operationality becomes worse.

Hint

: tape the screwdriver tip before use.

  1.  disconnect the connector, remove the heater control & accessory assy.

4. Install heater control & accessory assy

  1. Install the inner cable end of the air mix damper control cable to the heater control lever.
  2.  install the outer cable of the air mix damper control cable to the cable clamp.

Notice

:

  • be careful not to bend the cable wire.
  • If the cable wire bends, the heater control & accessory assy operationality becomes worse.

Hint

:

  • operating the heater control knob and check that it properly stops at both ends of max. Cool and max. Hot and no recoil is identified.
  • Check that the outer cable should not be disengaged (moved) from the heater control & accessory assy when the cable is pulled.

  1. Install the inner cable end of the defroster damper control cable to the heater control lever.
  2.  install the outer cable of the defroster damper control cable to the cable clamp.

Notice

:

  • be careful not to bend the cable wire.
  • If the cable wire bends, the heater control & accessory assy operationality becomes worse.

Hint

:

  • operating the heater control knob and check that it properly stops at both ends of face and def and no recoil is identified.
  • Check that the outer cable should not be disengaged (moved) from the heater control & accessory assy when the cable is pulled.
  1.  connect the connector, install the heater control & accessory assy.
    Share this page:

    Other materials:

    When using a child restraint system
    ■ When installing a child restraint system to a front passenger seat For the safety of a child, install a child restraint system to a rear seat. When installing a child restraint system to a front passenger seat is unavoidable, adjust the seat as follows and install the child restraint system: M ...

    Replacement
    Hint: components: 1. Table of bolt, screw and nut Notice: be sure to tape the tip of the screwdriver when using it to disengage the meshing of the clips and claws. Hint: indicate the bolts, screws and nuts, which are necessary for installation and removal of the instrument panel, in th ...

    Inspection procedure
    1 Check side air bag sensor assy lh Sst 09843–18040 Connect the negative (–) terminal cable to the battery, and wait at least for 2 seconds.  turn the ignition switch to on, and wait at least for 20 seconds.  clear the dtc stored in memory .  turn the ignition swi ...