Toyota Corolla (E120): Spiral cable sub–assy

Components

Replacement

Hint

: components:

1. Precaution

2. Disconnect battery negative terminal

3. Place front wheels facing straight ahead

  1.  check that the front wheels are facing straight ahead.

4. Remove horn button assy

5. Remove steering wheel assy

 sst 09950–50013 (09951–05010, 09952–05010, 09953–05020, 09954–05021)

6. Remove steering column cover

7. Remove spiral cable sub–assy

  1. Disconnect the airbag connector and the connector from the spiral cable sub–assy.
  2.  release the 3 claws and remove the spiral cable sub– assy.

8. Inspect spiral cable sub–assy

  1.  if the following condition is identified, replace the spiral cable sub–assy with a new one.

Condition

: scratches or cracks on the connector cracks, dents or chipping of the spiral cable sub–assy

9. Place front wheels facing straight ahead

  1.  check that the front wheels are facing straight ahead.

10. Install spiral cable sub–assy

  1.  set the turn signal switch in neutral position.

    Notice

    : make sure of the neutral position since the pin of the turn signal switch may be snapped.

  2.  engage the 3 claws and install the spiral cable sub–assy.

    Notice

    : when replacing the spiral cable sub–assy with a new one, remove the lock pin before installing the handle.

  3.  connect the airbag connector and the connector connecting to the spiral cable sub–assy.
  4.  install the steering column cover with the 3 screws.

11. Center spiral cable

  1.  check that the ignition switch is turned to off.
  2.  check that the battery negative terminal is disconnected.

Notice

: do not start the operation for 90 seconds after removing the terminal.

  1. Turn the cable counterclockwise by hand until it becomes harder to turn.

Hint

: the cable will rotate about 2.5 Turns to either left or right of the center.

  1. Then rotate the cable clockwise about 2.5 Turns to align the marks.

12. Install steering wheel assy

 torque: 50 nvm (510 kgfvcm, 37 ftvlbf)

13. Install horn button assy

 torque: 8.8 Nvm (90 kgfvcm, 78 in.Vlbf)

14. Inspect horn button assy

15. Inspect srs warning light

    Share this page:

    Other materials:

    How to proceed with troubleshooting
    The hand–held tester can be used at step 3, 4, 6, 9. 1 Vehicle brought to workshop 2 Customer problem analysis 3 Connect the obd ii scan tool or hand–held tester to dlc3 4 Check and clear dtc and freeze frame data 5 Visual inspection 6 Setting the check mode diagnosis 7 Proble ...

    Overhaul
    1. Remove console panel upper 2. Remove console box carpet 3. Remove parking brake hole cover sub–assy 4. Remove console box sub–assy rear 5. Disconnect floor shift cable transmission control shift Remove the cable end from the rod of the floor shift assembly. Using a s ...

    Clock assy
    Replacement 1. Remove console panel upper 2. Remove heater control knob 3. Remove instrument cluster finish panel 4. Remove clock assy Using a screwdriver, disengage the 4 claws, remove the clock as shown in the illustration. Hint: tape the screwdriver tip before use. ...