Toyota Corolla (E120): Replacement

Hint

: components:

1. Remove floor shift shift lever knob sub–assy

2. Remove console panel upper

3. Remove parking brake hole cover sub–assy

4. Remove console box sub–assy rear

5. Separate floor shift cable transmission control shift

  1. Separate the end of the shift cable from the shift lever assy.

  1. Using a screwdriver, release the cable outer spring.
  2.  turn the lock, separate the shift cable from the shift lever retainer.

6. Separate floor shift cable transmission control select

  1. Separate the end of the select cable from the shift lever assy.

  1. Using a screwdriver, release the cable outer spring.
  2.  turn the lock, separate the select cable from the shift lever retainer.

7. Remove floor shift shift lever assy

  1. Remove the 4 bolts and shift lever assy.

8. Install floor shift shift lever assy

  1. Install the shift lever assy with the 4 bolts.

    Torque: 12 nvm (120 Kgf·cm, 9 ft·lbf)

9. Connect floor shift cable transmission control shift

  1. Connect the shift cable to the retainer of shift lever assy, turn the lock.

    Notice

    : the projecting part of the lock should face upward when the shift cable is installed.

  2.  install the cable outer spring to the lock.

    Notice

    : make sure that after installation the cable outer spring is moved to the place shown in the illustration.

  1. Connect the end of the shift cable to the shift lever assy.

10. Connect floor shift cable transmission control select

  1.  connect the select cable to the retainer of shift lever assy, turn the lock.

    Notice

    : the projecting part of the lock should face upward when the select cable is installed.

  2.  install the cable outer spring to the lock.

    Notice

    : make sure that after installation the cable outer spring is moved to the place shown in the illustration.

  1. Connect the end of the select cable to the shift lever assy.
    Share this page:

    Other materials:

    Evap monitor (vacuum pressure monitor) (continued)
    Preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less.* Engine coolant temperature (ect) is between 40°f and 95°f (4.4 °C and 35 °C). Intake air temperature (iat) is between 40°f and 95 ...

    Overhaul
    1. Remove console panel upper 2. Remove console box carpet 3. Remove parking brake hole cover sub–assy 4. Remove console box sub–assy rear 5. Disconnect floor shift cable transmission control shift Remove the cable end from the rod of the floor shift assembly. Using a s ...

    Overhaul
    Hint: components: 1. Drain manual transaxle oil (m/t transaxle) torque: 39.2 Nvm (400 Kgf·cm, 29 ft·lbf) 2. Drain automatic transaxle fluid (a/t transaxle) torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 3. Remove front wheel 4. Remove engine under cover lh 5. Remove front axle hub lh nut ...