Toyota Corolla (E120): Inspection procedure

1 Inspect dlc3 terminal voltage(ts terminal)

  1. Turn the ignition switch to on.
  2. measure voltage between terminals ts and cg of dlc3.

    Ok: voltage: 10 – 14 v

2 Check harness and connector(dlc3 – body ground)

2 Check harness and connector(dlc3 – body ground)

  1. Check for open and short circuit in harness and connector between terminal cg of the dlc3 and body ground

3 Check harness and connector(skid control ecu – dlc3)

3 Check harness and connector(skid control ecu – dlc3)

  1. Check for open and short circuit in harness and connector between terminal ts of the dlc3 and skid control ecu

Check and replace brake actuator assy

Check and replace brake actuator assy

    Share this page:

    Other materials:

    Overhaul
    Notice: when installing, coat the parts indicated by the arrow with power steering fluid or molybdenum disulfide lithium base grease. 1. Precaution 2. Disconnect battery negative terminal 3. Inspect center front wheel 4. Remove horn button assy 5. Remove steering wheel assy sst 09950–50013 ...

    Inspection procedure
    Hint: read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, it is useful for determining whether the vehicle was running or stopped, the engine was warmed up or not, the ...

    Replacement
    Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove instrument panel sub–assy lower Remove the screw from the glove compartment door stopper sub–assy.  pull the instrument panel sub–assy lower to remove it. 4. Separate passenger airbag co ...