Toyota Corolla (E120): Floor shift cable transmission control select

Replacement

Hint

: components:

1. Remove air conditioner unit assy

H

int

: refer to the instructions for removal of the air conditioner unit assy.

2. Separate air bag sensor assy center

  1.  remove the 3 bolts, separate the airbag sensor assy center.

3. Remove exhaust pipe assy

4. Remove front floor heat insulator no.1

  1.  remove the 3 nuts and heat insulator no.1.

5. Remove floor shift cable transmission control select

  1. Remove the clip and washer, separate the top of the select cable from the transaxle.
  2.  remove the clip, separate the select cable from the control cable bracket.

  1. Remove the 2 nuts and clamp.

  1. Using a screwdriver, release the cable outer spring.
  2.  turn the lock, separate the select cable from the shift lever retainer.

  1. Separate the end of the select cable from the shift lever assy.

  1. Remove the 2 bolts and retainer from the floor.
  2.  pull out the control cable assy from the floor.

  1. Remove the retainer from the grommet.
  2.  remove the select cable from the grommet.

6. Install floor shift cable transmission control select

  1. Install the select cable to the grommet.
  2.  install the retainer to the grommet.

Notice

: fit 4 projections of the grommet into 4 holes of the retainer.

  1. Install the control cable assy with the 2 bolts.

    Torque: 5.0 Nvm (51 Kgf·cm, 44 in.Vlbf)

  1. Connect the end of the select cable to the shift lever assy.

  1. Connect the select cable to the retainer of shift lever assy, turn the lock.

    Notice

    : the projecting part of the lock should face upward when the select cable is installed.

  2.  install the cable outer spring to the lock.

    Notice

    : make sure that after installation the cable outer spring is moved to the place shown in the illustration.

  1. Install the clamp with the 2 nuts.

    Torque: 5.0 Nvm (51 Kgf·cm, 44 in.Vlbf)

  1. Connect the select cable to the control cable bracket, install a new clip.
  2. connect the select cable to the transaxle, install the washer and clip.

7. Install front floor heat insulator no.1

  1.  install the heat insulator no.1 With the 3 nuts.

8. Install exhaust pipe assy

9. Connect air bag sensor assy center

  1.  install the airbag sensor assy center with the 3 bolts.

    Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf)

10. Inspect srs warning light

    Share this page:

    Other materials:

    Checking and replacing fuses
    If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. 1 Turn the engine switch off. 2 Open the fuse box cover. ► Engine compartment Push the tab in and lift the lid off. ► Under the driver’s side i ...

    Manual transaxle oil
    On–vehicle inspection 1. Inspect transaxle oil Stop the vehicle on the level place.  remove the transmission filler plug and gasket.  check that the oil surface is within 5 mm (0.20 In.) From the lowest position of the inner surface of the transmission filler plug openin ...

    Outside vehicle
    General maintenance Performing these maintenance checks on the vehicle in the owner’s responsibility. The owner may perform the maintenance or take the vehicle to a service center. Check the parts of the vehicle described below on a daily basis. In most cases, special tool are not requir ...