Toyota Corolla (E120): Check short circuit

  1. If the wire harness is ground shorted as shown in fig. 5, Locate the section by conducting a resistance check with the body ground in step (b).

  1. Check the resistance with the body ground.
  1.  Disconnect connectors a and c and measure the resistance between terminals 1 and 2 of connector a and the body ground.

    Resistance: 10 kΩ or higher

Hint

: measure the resistance while lightly shaking the wire harness vertically and horizontally. In the case of fig. 6: Between terminal 1 of connector a and body ground " below 1 Ω

between terminal 2 of connector a and body ground " 10 kΩ

or higher therefore, the cause is a short circuit between terminal 1 of connector a and terminal 1 of connector c.

  1. Disconnect connector b and measure the resistance between terminal 1 of connector a and the body ground, and terminal 1 of connector b2 and the body ground.

    In the case of fig. 7: Between terminal 1 of connector a and body ground " 10 kw or higher between terminal 1 of connector b2 and body ground " below 1 w therefore, the cause is a short circuit between terminal 1 of connector b2 and terminal 1 of connector c.

Check and replace ecu

    Share this page:

    Other materials:

    Vehicle information
    This screen can be used to display the fuel consumption. “Trip Information” or “Past Record” screen Press “CAR” to display the “Trip Information” or “Past Record” screen. Fuel consumption ■ Trip information If the “Trip Information” screen does not appear, select ...

    Pre–check
    1. Diagnosis check Starting diagnosis mode (service check mode)  turn off the audio system and turn the ig switch to acc. While pressing the preset switches ”1” and ”6” at the same time, press ”cd” 3 times. Reference: beep sound is given 3 times and the sys ...

    Inspection
    1. Spark plug Notice: never use a wire brush for cleaning. Never attempt to adjust the electrode gap on used spark plug. Spark plug should be replaced every 192,000 km (120,000 miles). Clean the spark plugs. Air pressure: below 588 kpa (6.0 Kg/cm2, 85 psi) duration: 20 sec ...