Toyota Corolla (E120): Wiper rubber lh

Replacement

1. Remove fr wiper blade lh

  1.  remove the front wiper blade lh from the front wiper arm lh.

Notice

: do not fold down the front wiper arm with the front wiper blade being removed from it.

2. Remove wiper rubber lh

  1.  remove the front wiper rubber lh from the front wiper blade.
  2.  remove the 2 wiper rubber backing plates from the wiper rubber lh.

3. Install wiper rubber lh

  1. Install the 2 wiper rubber backing plates to the wiper rubber lh.

Notice

: be careful to observe and keep direction of curvature for correct replacement.

  1. Install the wiper rubber lh so that the head part (larger side) of the wiper rubber faces the arm axie side.

Notice

: push the front wiper blade into the grooves of the wiper rubber to engage them completely.

    Share this page:

    Other materials:

    Speed sensor front lh
    Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove front wheel 2. Remove front fender liner lh 3. Remove speed sensor front lh Disconnect the speed sensor wire harness clamp from the body.  disconnect the speed sensor connector. Remo ...

    Circuit description
    The srs warning light is located on the combination meter. When the srs is normal, the srs warning light lights up for approx. 6 Seconds after the ignition switch is turned from the lock position to on position, and then turns off automatically. If there is a malfunction is the srs, the srs ...

    Circuit description
    The intake air temperature (iat) sensor, mounted on the mass air flow (maf) sensor, monitors the intake air temperature. The iat sensor has a thermistor that varies its resistance depending on the temperature of the intake air. When the air temperature is low, the resistance in the thermisto ...