Toyota Corolla (E120): Windshield wiper switch assy

Replacement

1. Remove steering column cover lwr

  1. Remove 3 screws and steering column cover lwr.

2. Remove windshield wiper switch assy

  1. Disconnect the connecter of the windshield wiper switch.
  2.  release the claw and pull out the windshield wiper switch assy as shown in the illustration.

Notice

: pressing the claw hard breaks the claw.

    Share this page:

    Other materials:

    Overhaul
    1. Precaution 2. Disconnect battery negative terminal 3. Inspect place front wheels facing straight ahead 4. Remove horn button assy Notice: if the airbag connector is disconnected with the ignition switch being at on, dtcs will be recorded.  using a torx socket wrench, loosen the ...

    If the shift lever cannot be shifted from P (except vehicles with a manual transmission)
    If the shift lever cannot be shifted with your foot on the brake pedal, there may be a problem with the shift lock system (a system to prevent accidental operation of the shift lever). Have the vehicle inspected by your Toyota dealer immediately. The following steps may be used as an emergency ...

    Overhaul
    Hint: components: 1. Drain manual transaxle oil (m/t transaxle) torque: 39.2 Nvm (400 Kgf·cm, 29 ft·lbf) 2. Drain automatic transaxle fluid (a/t transaxle) torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 3. Remove front wheel 4. Remove engine under cover lh 5. Remove front axle hub lh nut ...