Toyota Corolla (E170): Using the AUX port

To use the AUX port, connect a portable player, press the “AUDIO” button, then select “AUX” to display the audio control screen.

Connecting a portable audio player

■Operating portable audio players connected to the multimedia system

The volume can be adjusted using the vehicle's audio controls. All other adjustments must be made on the portable audio player itself.

■When using a portable audio player connected to the power outlet

Noise may occur during playback. Use the power source of the portable audio player.

CAUTION

■While driving

Do not connect a portable audio player or operate the device controls.

    Share this page:

    Other materials:

    Out side moulding
    Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove outside moulding Put protective tape around the moulding.  insert a piano wire between the vehicle body and moulding.  tie objects that can serve as handles (for example, wooden blocks) to all ...

    Inspection procedure
    1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat outer belt assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...

    Replacement
    1. Remove instrument panel sub–assy lower 2. Remove clutch pedal spring 3. Remove clutch master cylinder push rod clevis w/hole pin Remove the clip and hole pin. 4. Remove clutch pedal support sub–assy W/ cruise control: disconnect the clutch switch assy connector. &nbs ...