Toyota Corolla (E170): Taking out the spare tire

1 Remove the luggage floor cover. 2 Remove the tool tray.

3 Loosen the center fastener that secures the spare tire.

3 Loosen the center fastener that secures the spare tire.

CAUTION

CAUTION

■When storing the spare tire

Be careful not to catch fingers or other body parts between the spare tire and the body of the vehicle.

    Share this page:

    Other materials:

    Removal and installation of engine intake parts
    If any metal tip is mixed in the inlet pass, this may give a bad effect to the engine and turbocharger.  when removing and installing the inlet system parts, close the opening of the removed inlet system parts and the engine with a clean shop rag or gummed tape.  when inst ...

    Oxygen sensor monitor (front and rear o2s system)
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

    Inspection procedure
    1 Check source voltage Measure the voltage of the battery. Ok: voltage: 10 – 14 v 2 Check air bag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors from the airbag sensor assy ...