Toyota Corolla (E170): Stopping the engine

1 Stop the vehicle.

2 Continuously variable transmission: Shift the shift lever to P.

Manual transmission: Shift the shift lever to N.

3 Set the parking brake. 4 Press the engine switch.

5 Vehicles without a multi-information display: Release the brake pedal (continuously variable transmission) or clutch pedal (manual transmission) and check that the smart key system indicator light (green) is off.

Vehicles with a multi-information display: Release the brake pedal (continuously variable transmission) or clutch pedal (manual transmission) and check that “POWER ON” on the multi-information display is off.

    Share this page:

    Other materials:

    Front differential oil seal (atm)
    Replacement 1. Remove front wheels 2. Remove engine under cover rh 3. Remove engine under cover lh 4. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 5. Remove fron ...

    Check open circuit
    For the open circuit in the wire harness in fig. 1, Perform a resistance check in step (b) or a voltage check in step (c) to locate the section. Check the resistance.  Disconnect connectors a and c and measure the resistance between them. Resistance: 1 Ω or les ...

    How to proceed with troubleshooting
    Hint: carry out troubleshooting in accordance with the procedures on the following page. Here, only the basic procedures are shown. Details are provided in the diagnostics section, showing the most effective methods for each circuit. Confirm the troubleshooting procedures first for the releva ...