Toyota Corolla (E120) 2002–2008 Repair Manual / Starting & charging / Starter assy (1zz–fe)
Toyota Corolla (E120): Starter assy (1zz–fe)
Other materials:
Check open circuit
For the open circuit in the wire harness in fig. 1, Perform
a resistance check in step (b) or a voltage check in step
(c) to locate the section.
Check the resistance.
Disconnect connectors a and c and measure the
resistance between them.
Resistance: 1 Ω or les ...
Terminals of ecu
1. Inspect integration relay
Disconnect the connector and check the continuity of each terminal of
the disconnected connector.
Standard :
If the result is not as specified, the vehicle’s side may malfunction.
Reconnect the connector and check each terminal.
Standard:
If ...
Oxygen / af sensor heater monitor
Preconditions
The monitor will not run unless:
mil is off
drive pattern
connect the obd ii scan tool to the dlc3 to check monitor status
and preconditions.
Start the engine and allow it to idle for 9 minutes.
Drive the vehicle at 25 mph (40 km ...


