Toyota Corolla (E120): Seat belt warning system

Share this page:

Other materials:

Inspection procedure
1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

Temporarily engaged gear steps selection mode in the D position
To drive in temporary gear steps selection mode, operate the “-” and “+” paddle shift switches. The gear steps can then be selected by operating the “-” and “+” paddle shift switches. By selecting gear step using paddle shift switches, you can control engine braking forces. 1 ...

Wiring diagram
1 Inspect terminal voltage(pi) (a) turn Turn the ignition switch to on.  measure voltage between terminal 5 (pi) of cruise control ecu assy and body ground, when the cruise control main switch button is on and off. Ok: 2 Inspect combination meter assy 3 Check harn ...